Description
ADLINK's Motionnet products provide system integrators with a simple configuration and reduced wiring method for a cost-effective solution for motion applications utilizing multiple single axis. With this new concept of direct plug-in modules, the amount of space used and the amount of wiring required is greatly reduced from traditional terminal board connections. After the module is plugged into the servo driver, all that is needed is a LAN cable to make the serial connection between the modules. Different servo drivers can be lined up on the Motionnet bus, making motion control configuration much simpler than PCI board solutions. The Motionnet bus can support up to 64 single-axis modules.
- No command frequency limitation
- Available for Delta A2, and Sanyo R series
- Up to 64 axes, serially connected
- No need for terminal boards-reduces space
- The scanning cycle time up to 0.97 ms at 20 Mbps when 64 axes are connected
- Point-to-point application can be easily completed with multiple single-axis modules
- Support linear/s-curve acceleration and deceleration
MNET-DA2 Motionnet distributed single-axis motion control module for Delta A2
MNET-SAN Motionnet distributed single-axis motion control module for Sanyo R series
Recommended Products
PCI-7856 Master-Slave Distributed Motion & I/O Master Controller
DPAC-3000 series Distributed Programmable Automation Controller with HSL and Motionnet Buses (Intel® Atom™ N270 1.6 GHz CPU)
